3DLac 400ml spray adhesive for better adhesion with FDM printers

3DLac Spray Adhesive

3DLac is a spray adhesive for the build plate. The spray adhesive was developed by a Spanish laboratory specifically for 3D printers using the FDM process.

3DLac is fragrance-free, high-temperature resistant, and contains an enhanced fixative to help components better adhere to the build plate.

Safety Instructions:

• P101 - If medical advice is needed, have product container or label at hand.
• P102 - Keep out of reach of children.
• P210 - Keep away from heat, hot surfaces, sparks, open flames, and other ignition sources. No smoking.
• P211 - Do not spray on an open flame or other ignition source.
• P251 - Do not pierce or burn, even after use.
• P264 - Wash thoroughly after handling with plenty of water.
• P280 - Wear protective gloves / protective clothing / eye protection / face protection.
• P305+P351+P338 - If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
• P410+P412 - Protect from sunlight and do not expose to temperatures exceeding 50°C.
• P501 - Dispose of contents/container to an appropriate waste disposal facility.

Hazard Warnings:

• H222 - Extremely flammable aerosol.
• H229 - Pressurized container: may burst if heated.
• H319 - Causes serious eye irritation.
• H336 - May cause drowsiness or dizziness.